|
|
|
 |
AUTOart #13301 Motor
Direct replacment motor for the Ford Mustang, Porsche 911 GT3R and Ford GT. The can drive motor shaft is the same length as a Ninco NC-1. 26000 rpm at 12.0 volts. Axle Length: 38 mm.
|
|
$ 5.95
Available: 7
More Information
|
|
 |
AUTOart #13302 Motor w/ 10T Pinion Gear
Direct replacment motor for the Lamborghini Diablo GTR. The motor shaft extends from both sides of the motor to fit most 1/32 slot cars. The can drive end of the motor shaft is the same length as a Ninco NC-1 (slightly shorter than the Artin motor shaft). You may have to cut the unused motor shaft to install in some cars. 26000 rpm at 12.0 volts. Axle Length: 45 mm.
|
|
$ 5.95
Available: 1
More Information
|
|
 |
Hobby Slot Pinion Press Assisting Tool
For use in conjunction with the NINCO #80201 Pinion Press & Puller Tool for a precise installation of the pinion gear on the motor. The tool captures the motor for a true alignment as it tracks on the NINCO tool. The small round bushing is used on the end of the motor and captures the tip of the press to prevent it from moving out of position.
|
|
$ 6.99
Available: 2
More Information
|
|
 |
Hobby Slot Racing HSR-1 Motor w/ 10T Pinion Gear
Endbell drive, short casing motor. 19,000 rpm at 14.8 volts.
|
|
$ 10.99
Available: 2
More Information
|
|
 |
Hobby Slot Racing HSR-3 Motor
Competition long can (Ninco NC-5 size) motor. 23,000 rpm at 14.8 volts. Lead wire and pinion gear not included.
|
|
$ 17.95
Available: 5
More Information
|
|
|
|
Hobby Slot Racing Motor Mounting Screws (8)
Motor mounting screws are used to mount an NC-5 size motor to the chassis. On some chassis you will have to drill the holes on the motor mounting bracket to accept these screws.
|
|
$ 3.50
Available: 11
More Information
|
|
 |
Monogram #5113 High-Performance Motor
Hop up motor for all Monogram 1:32 slot cars.
Can be used with most other 1:32 slot cars including Carrera, Ninco and Scalextric.
|
|
$ 10.00
Available: 3
More Information
|
|
 |
Ninco #80201 Pinion Press & Puller Tool
Hardened steel tool to remove and install all kinds of motor pinions including "inline" and "anglewinder" gears.
|
|
$ 16.95
Available: 3
More Information
|
|
|
|
Ninco #80608 Motor Adapter NC-2/3/5/6 to NC-1
This motor adapter is used to mount an NC-1 size motor in a NC-2/3/5/6 motor mount.
|
|
$ 4.95
Available: 2
More Information
|
|
 |
Ninco #80610 NC-5 Speeder Motor
Competition motor. 20,000 rpm at 14.8 volts, 290 gcm. Suitable for rally and speed racing, progressive acceleration and braking.
|
|
$ 21.95
Available: 4
More Information
|
|
|
|
